Synthesis of 4-[(1,3-diaminopyrrolo[3′,4′:4,5]pyrido[2,3-d]-pyrimidin-8-yl)benzoyl]-L-glutamic acid as a potential antifolate

This paper is dedicated to the memory of Professor Roland K. Robins The synthesis of 4-[(1,3-diaminopyrrolo[3′,4′:4,5]pyrido[2,3-d]pyrimidin-8-yl)benzoyl]-L-glutamic acid ( 18 ), a potential antifolate and anticancer agent, has been achieved starting from 1,4-dibromobutan-2-ol with alkyl p-aminobenzoic acids. Condensation of these two agents gave 1-(4-alkoxycarbonylphenyl)pyrrolidin-3-ols 7a,b , which were oxidized to the corresponding pyrrolidin-3-one derivatives 8a,b . Compounds 8a,b were converted into 1,3-diamino-8-(4-alkoxycarbonylphenyl)-7,8-dihydro-9H-pyrrolo[3′,4′:4,5]pyrido[2,3-d]pyrimidines 12a,b in 4 steps. Saponification of 12b the benzoate ester and coupling with di-tert-butyl glutamate afforded a mixture of 7,8-dihydro product 16 and its aromatized derivative 17 . Finally hydrolysis of esters 16 or 17 gave only the title compound 18 . The 7,8-dihydro tricyclic derivatives were easily air-oxidized to form their fully aromatized compounds. The title compound 18 was one tenth less active than MTX against HL-60 cells in culture.     

三辛基氧化膦(TOPO)萃取铟的研究

本文研究了三辛基氧化膦(TOPO)自盐酸溶液中萃取铟的性能,其萃取率是随酸度的增加而增加。与P_(350)和TBP相比较,萃取能力大小顺序为:TOPO>P_(350)>TBP经斜率法和化学分析法研究确定,TOPO白盐酸溶液中萃取铟的反应为:In_((a))~(3+)+H_((a))~++4Cl_((a))~-+2TOPO_((o))F(?)HInCl_4·2TOPO_((o))IR和NMR研究证明:铟是以H[InCl_4]形式被萃入TOPO有机相中的。     

Effect of take-up speed on physical properties and permeation performance of cellulose acetate hollow fibers

Cellulose acetate (CA) ultrafiltration hollow fibers were spun via the dry-jet wet spinning technique. The effect of the take-up speed on the mechanical properties, morphology, thermal properties, pure water permeation, retention, and surface characterization of hollow fiber membranes were investigated. Both the inner and outer diameters of the hollow fiber decreased with the increase of take-up speed. Macrovoids were observed on the inner surface of the drawn hollow fibers. The d-space decreased with the increase of the take-up speed. The ultimate tensile stress (UTS) increased and the breaking elongation decreased with the increase of take-up speed. The permeation performance was measured. The hydraulic permeability increased and the retention decreased slightly with the increase of the take-up speed. The surface roughness increased with the increase of the take-up speed. The thermal analysis results showed that the endothermic peak shifts to the higher temperature region and coefficient of thermal expansion (CTE) decrease for a higher take-up speed.     

Syntheses and PE-Spectroscopic Investigations of 2,6- and 3,5-Bridged 1,4-Dimethylidenecyclohexanes

Three 1,4-dimethylidenecyclohexanes, bridged in the 2,6- and 3,5-positions by two ethano ( 4 ), one ethano and one propano ( 5 ), and two propano bridges ( 6 ) have been synthesized. The interaction of the two exocyclic methylidene groups has been investigated by He(I) photoelectron (PE) spectroscopy. It revealed a slightly larger energy difference (0.8 eV) for 4 and 5 as compared to the parent 1,4-dimethylidenecyclohexane ( 7 ) (0.7 eV). The interpretation of the PE spectra was based on the comparison with PE data of related systems and with the results of semiempirical calculations on 4–6 .     

Ternary upper-critical-solution-temperature behavior in a blend system comprising poly(2,6-dimethyl-1,4-phenylene oxide), poly(4-methyl styrene), and polystyrene

 Upper-critical-solution-temperature (UCST) behavior in a ternary blend of poly(2,6-dimethyl-1,4-phenylene oxide), poly(4-methyl styrene), and polystyrene is reported. The as-cast ternary blend is immiscible at ambient conditions and comprises two different phases, and, however, turns into a miscible system above the “clarity point” ranging from 160 to 300 °C for different ternary compositions. The maximum clarity point is labeled as the UCST for the ternary system, which is about 295 °C. Above the clarity point, the originally immiscible ternary blend turned into one miscible phase. Owing to the thermodynamic UCST behavior and kinetic hindrance, the immiscible ternary polymer blend can be locked into a pseudo-miscible state if it is heated to a temperature above the clarity point followed by a rapid-cooling processing scheme. The quenched ternary blend can remain in a pseudo-miscible state as long as the service temperature does not exceed the glass-transition temperature of the blend. Received: 17 July 2001 Accepted: 3 October 2001     

Experimental and theoretical studies of rate coefficients for the reaction O(3P)+CH3OH at high temperatures

Rate coefficients of the reaction O((3)P) + CH(3)OH in the temperature range of 835-1777 K were determined using a diaphragmless shock tube. O atoms were generated by photolysis of SO(2) with a KrF excimer laser at 248 nm or an ArF excimer laser at 193 nm; their concentrations were monitored via atomic resonance absorption excited by emission from a microwave-discharged mixture of O(2) and He. The rate coefficients determined for the temperature range can be represented by the Arrhenius equation, k(T) = (2.29 +/- 0.18) x 10(-10) exp[-(4210 +/- 100)T] cm(3) molecule(-1) s(-1); unless otherwise noted, all the listed errors represent one standard deviation in fitting. Combination of these and previous data at lower temperature shows a non-Arrhenius behavior described as the three-parameter equation, k(T) = (2.74 +/- 0.07) x 10(-18)T(2.25 +/- 0.13) exp[-(1500 +/- 90)T] cm(3)molecule(-1) s(-1). Theoretical calculations at the Becke-3-Lee-Yang-Parr (B3LYP)6-311 + G(3df,2p) level locate three transition states. Based on the energies computed with coupled clusters singles, doubles (triples) [CCSD(T)]/6-311 + G(3df,2p)B3LYP6-311 + G(3df,2p), the rate coefficients predicted with canonical variational transition state theory with small curvature tunneling corrections agree satisfactorily with the experimental observations. The branching ratios of two accessible reaction channels forming OH + CH(2)OH (1a) and OH + CH(3)O (1b) are predicted to vary strongly with temperature. At 300 K, reaction (1a) dominates, whereas reaction (1b) becomes more important than reaction (1a) above 1700 K.     

Dual room-temperature fluorescent and phosphorescent emission in 8-quinolinolate osmium(II) carbonyl complexes: rationalization and generalization of intersystem crossing dynamics

A new series of quinolinolate osmium carbonyl complexes were synthesized and characterized by spectroscopic methods. Single-crystal X-ray diffraction studies indicate that these complexes consist of an octahedral ligand arrangement with one chelating quinolinolate, one tfa or halide ligand, and three mutually orthogonal terminal CO ligands. Variation of the substituents on quinolinolate ligands imposes obvious electronic or structural effects, while changing the tfa ligand to an electron-donating iodide slightly increases the charge density on the central osmium atom. These Os(II) complexes show salient dual emissions consisting of fluorescence and phosphorescence, the spectral properties and relaxation dynamics of which have been studied comprehensively. The results, in combination with the theoretical approaches, lead us to propose that the emission mainly originates from the quinolinolate pi pi* state. Both experimental and theoretical approaches generalize various types of intersystem crossing versus those of the tris(quinolinolate) iridium Ir(Q)3, and their relative efficiencies were accessed on the basis of the associated frontier orbital configurations. Our results suggest that [1d(pi)pi* absolute value(H(so))3 pi pi*] (or [3d(pi)pi* absolute value(H(so))1 pi pi*]) in combination with a smaller deltaE(S1-T1) gap (i.e., increasing the MLCT (d(pi)pi*) character) is the main driving force to induce the ultrafast S1 --> T1 intersystem crossing in the third-row transition metal complexes, giving the strong phosphorescent emission.     

Speciation of bound and free metals evaluated for lobster digestive gland extracts

A simple method is described for the speciation of metalions in biological extracts with a short desalting gel-filtration column. The system was optimized for the eluent and gel type to provide accurate free metal ion levels and minimum processing times. The four separation media studied were Sephadex G25, Bio-Gel P-6DG, controlled pore glass CPG40, and Fractogel HW40F. The best medium was the Fractogel HW40F because it was not compressible and allowed a pump to be used to obtain uniform flow rates. The eluent was 0.10 M ammonium acetate/0.01 M citric acid adjusted to pH 7.0. This eluent minimized ion/gel interactions and gave a lower salt content relative to other possible eluents. The separation time was 10 min per sample per metal ion of interest. The detection limits relative to the mass of wet tissue for the column/flame spectrometer system were 0.80 μg g^?1, 0.80 μg g^?1, and 1.6 μg g^?1 for zinc, cadmium and copper, respectively. The method is evaluated for a lobster digestive gland extract; the methodology should be applicable to other systems containing nonlabile metal species.